![stanley professional 7100 manual stanley professional 7100 manual](https://www.manua.ls/thumbs/products/s/1079443-stanley-al24.jpg)
This is often caused by something inside the safe pressing against the door or by something caught between the safe door and its frame. The boltwork of a safe can, under certain conditions, place pressure on the side of the lock’s bolt.
#Stanley professional 7100 manual code
If your lock should fail to open when a valid code is entered, check for the following:ġ. Note: The Master Code Holder is responsible for maintaining the number of active users programmed into each lock. To re-lock the S&G © D-Drive ™, turn the keypad back counterclockwise to stop. Do not put any pressure on the safe handle until after the keypad has been turned. Then, within six seconds, turn the keypad clockwise about 70 degrees, until it comes to a positive stop. Press the code digits or letters in order, followed by #. Make sure the keypad is turned counterclockwise to stop. Note: This lock has been Listed by Underwriters Laboratories for use with the following S&G keypad(s): 6130-2XX and 6130-3XX Make sure it functions correctly before closing the door.
![stanley professional 7100 manual stanley professional 7100 manual](https://thetoolstorett.com/home/wp-content/uploads/2020/08/FIM0P05701.jpg)
After the lock is changed to a new code, the lock function must checked by locking and unlocking it several times with the container door open.Personal data which can be directly related to a code holder, such as a birthdate, should not be used in making up a lock code.For UL installations, the maximum number of working codes allowed is one.If the lock emits two long error tones (braps) during repeated programming attempts, it is in lockout mode. The lock can also go into the lockout period during programming if it interprets an incorrect programming sequence as five or more consecutive incorrect code entries. Pressing any buttons during the lockout period will not affect the penalty timer.Īfter ten minutes, the lock should operate normally. Entering a code during this period will result in two long error tones (braps). If five incorrect codes are entered in a row, the S&G © X 03 D- Drive ™ lock will shut down for a period of ten minutes.If you realize you have pressed an incorrect button when entering a code, press or simply pause ten seconds or more, then begin entering your code again.To open the lock,īegin the code entry sequence once again from the first step. If you pause more than 10 seconds between button presses when entering a code, the lock will assume you do not want to continue, and it will reset itself to the original code.This signals the lock that you have finished entering all digits of the code. PO Box 930, Nicholasville, Kentucky 40356 USA For instance, the following codes (while not recommended) will operate theĪ Wholly Owned Subsidiary of Stanley Security Solutions, Inc. Any digit or letter can be used as many times as you wish. All codes must contain six digits or six letters.
![stanley professional 7100 manual stanley professional 7100 manual](https://data2.manualslib.com/product_thumbs/20/98/9727/972668_stgs7115_product.png)
If it does not, check your battery (or batteries) to make sure it is fresh and connected properly, then try again.